Contents: Removal 🠛 Installation 🠛
Removal
- Remove the hub - brake drum assembly.
- Disconnect the line from the wheel cylinder.
- Remove the brake shoe backplate mounting stud retaining nut, marking it to return it to its original position.
- Remove the six bolts securing the brake shoe support shield to the hub journal. Hang the support shield to the rear suspension beam.
- Remove the ABS sensor mounting bolt.
Installation
- Installation is carried out in the reverse order of removal.
- If the trunnion bolts are reused, they should be coated with Loctite FRENBLOC.
- Tighten the trunnion mounting bolts in the sequence 1-2-3-4-5-6 to a torque of 30 Nm (Fig. 11.5).
- Tighten the hub nut to 170 Nm.
- Remove air from the brake system
Fig. 11.4. Location of the rear wheel hub mounting nut
Fig. 11.5. Sequence of tightening the bolts for fastening the journal and the brake shoe support shield