Removing
Cars of the 1st and 2nd stages of production
Worm-type window regulators
1. Remove the door trim (see chapter 8).
2. Fix the glass in its highest position with adhesive tape or wedges.
3. Turn away two bolts of fastening of a clip of glass to directing.
4. Turn away the screw of fastening of the handle of a window regulator to a door.
5. Remove the two bolts at the top and one screw at the bottom of the power window guide to the door.
6. Remove the guide tube.
7. Tilt the entire assembly and side of the door lock and remove it.
Frame type windows
8. Secure the glass in its highest position with adhesive tape or wedges.
9. Turn away three bolts of fastening of a window regulator.
10. Take away branches of a window regulator back and remove them from guides.
11. Remove the entire assembly by tilting it down.
Cars of the 3rd stage of production
12. On vehicles with power rear windows: Disconnect the wire «masses» from the battery.
13. Remove the door trim (see chapter 11).
14. Install the glass in a position where the two bolts of its fastening in the holder will be opposite the two mounting holes in the door, and unscrew these bolts.
15. Secure the glass in its highest position with adhesive tape or wedges.
16. Disconnect a socket from the window regulator electric motor.
17. Turn away three bolts of fastening of the mechanism of a window regulator (and, if necessary, an electric motor) on the door.
18. Turn away two bolts above and one below fastenings directing window regulator to a door.
19. Tilt the entire assembly and remove.
Installation
20. Installation is carried out in the reverse order. Adjust the position of the glass cage so that when fully lowered and fully raised, it is in the correct position without excessive play in the guides.