Pic. 2.116. The order of tightening the bolts of the cover and cylinder head
Tighten in the order shown in figure 2.116 with the required moment:
- bolts of fastening of a head of the block of cylinders 13–20–22–23 (8 Nm),
- bolts of fastening of a cover of a head of cylinders with 1–12, with 14–19 and 21–24 (15 Nm).
Loosen the cylinder head cover bolts 13-20-22-23.
Tighten in the specified order the required moment bolts of fastening of a cover of a head of cylinders 13–20–22–23 (15 Nm).
Fasten the magnetic strut to the cylinder head using the mounting plate of the tool (Mot. 588), tightening it with oil separator mounting bolts and spacer bushings having the following dimensions:
- outer diameter 18 mm,
- bolt hole diameter 89 mm, height 15 mm (pic. 2.117).
Pic. 2.117. Installation of a magnetic rack on a head of the block of cylinders: 1 - mounting plate; 2 - spacer bushings; 3 - bolts
Pic. 2.118. Checking axial movement
Check the axial movement, which should be between 0.08–0.178 mm (pic. 2.118).
Remove the cylinder head cover and camshafts.