Tighten in the order shown in the figure to the required torque:
- cylinder head bolts 13 -20-22-23 (8 Nm),
- cylinder head cover bolts from 1-12, from 14-19 and 21-24 (15 Nm).
Loosen the cylinder head cover bolts 13-20-22 -23. Torque tighten the cylinder head cover bolts 13-20-22-23 in the order shown (15 Nm).
Fasten the magnetic strut to the cylinder head using the mounting plate of the tool (Mot. 588), tightening it with oil separator mounting bolts and spacer bushings having the following dimensions:
- outer diameter 18 mm,
- bolt hole diameter 89 mm, height 15 mm.
Installation of a magnetic rack on a head of the block of cylinders:
1 - mounting plate;
2 - spacer bushings;
3 - bolts.
Check the axial movement, which should be between 0.08-0.178 mm.
Remove the cylinder head cover and camshafts.