Flywheel (drive pulley) — removal and installation (Renault Espace I)

1. The flywheel is secured to the crankshaft with seven bolts with lock washers or, in most cases, without lock washers. If the flywheel bolts are installed without washers, they must be replaced each time. When installing the flywheel, lubricate the bolt threads with protective grease "Loctite". Observe the tightening torque (see specifications).

2. To remove or install the flywheel, the crankshaft must be blocked. If the oil pan has not yet been installed, a wooden block can be installed between the crankshaft counterweight and the cylinder block, or the flywheel can be blocked with a screwdriver. Bend back the tongue of the lock washer and remove it with pliers. Do not use an Allen key for this.

3. The alternator drive pulley does not use a lock washer (v6 engine). Bolts should always be replaced. Lubricate the threads with "Loctite". There is a guide disc on each side of the drive pulley (see illustration). The tightening torque of the bolts is 65-75 Nm.