Removal and installation the exhaust gas pressure sensor
Removal the exhaust gas pressure sensor
1. Place the vehicle on a two-post lift.
2. Remove the air filter unit.
3. Loosen the mounting bolts and remove the engine protective pan.
4. Disconnect the oil vapor recirculation pipe connector from the rocker arm cover (1).
5. Unscrew the bolt (2) of the turbocharger air outlet duct from the lifting eye.
6. Unscrew the nut (3) of the turbocharger air outlet duct from the EGR.
7. Unclip the clamp (4) of the turbocharger air outlet duct.
8. Unhook and disconnect the air outlet duct from the turbocharger.
9. Disconnect the exhaust gas pressure sensor connector (5).
10. Remove the clamp (6) of the exhaust gas pressure sensor.
11. Loosen the hollow bolt (7) and remove the exhaust gas pressure sensor from the exhaust manifold.
Installing an Exhaust Gas Pressure Sensor
Installation is carried out in the reverse order of removal.
Note: Be sure to replace the exhaust gas sensor clamp with a new one. The tightening torque of the exhaust gas pressure sensor hollow bolt is 32 N·m.
You can find the original at this link: RenaultBook