Note. The replacement of sensors and switches is shown using the example of a Renault/Dacia Sandero with a K7J or K7M engine. Replace the sensors and switches of a car with a K4M engine in a similar manner.
The oil pressure warning light sensor is installed at the rear of the cylinder block on the right side (next to the engine number).
You will need a 22 mm wrench.
1. Disconnect the wire from the negative terminal of the battery.
2. Press the lock and disconnect the wiring harness connector from the sensor.
3. Loosen the sensor tightening with a wrench...
4. ...and unscrew it from the cylinder block.
View the original on the specified resource: renaultbook
5. Note the presence of a sealing washer.
6. Install the sensor in the reverse order of removal.