Removal and installation the multifunctional support (Renault Logan 2)

Removal

1. Place the vehicle on a two-post lift.

2. Disconnect the negative battery terminal.

3. Loosen the mounting bolts and remove the engine protective pan.

4. Remove the accessory drive belt.

5. Remove the generator from the engine.

6. Loosen the power steering pump mounting bolts.

7. Attach the power steering pump to the subframe.

8. Loosen the bolts (1) and remove the multifunctional support from the engine.

[Original article is on the portal www.RenaultBook.ru]

8. Loosen the bolts (1) and remove the multifunctional support from the engine.

Installation

1. Install the multifunctional support and tighten the mounting bolts without tightening.

2. Tighten the multifunctional support mounting bolts in the specified sequence to a torque of 44 N·m.

2. Tighten the multifunctional support mounting bolts in the specified sequence to a torque of 44…

3. Install the power steering pump and tighten the mounting bolts.

4. Install the generator.

5. Install the accessory drive belt.

6. Install the engine protective pan.

7. Connect the battery

This article is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article has been reviewed by editor: Petrovsky Roman

Share with friends:

Logan 2: Petrol engines 1.6 l

Removal and installation the power steering pump
Removal and installation the air conditioning compressor
Engine attachments
Compression check
Preparing for repairs

Removal and installation of the power unit assembly
Repair of an engine removed from a car
Removal components from the top of the engine
Checking the technical condition and repairing the upper engine…
Removal components from the bottom of the engine