Adjustment
Loosen the mounting bolts (1) multifunction switch. Set hex wrench to 3mm (2) on the drive lever and align the axis of the tool with the hole in the multifunction switch (3).
Torque tighten the multifunction switch mounting bolts 6 Nm.
Take out the hex key (2).
In case of replacement of the spool valve, reset the self-tuning parameters using the command: RZ005 «Resetting bootstrap parameters» and reset the automatic transmission fluid life counter using the diagnostic tool by entering the command: CF074 «Recording the date of fluid change in the gearbox».
After executing the RZ005 command, be sure to perform a trip with repeated shifts to higher and lower gears to enter new values and settings into the memory.
Removing
Set aside the wiring harness bracket (1).
Disconnect the multifunction switch connector (2).
Turn away bolts (3) mounting the multifunction switch. Lift multifunction switch (4).
Move the multifunction switch aside.
Disconnect the multifunction switch drive lever from the gearbox control drive linkage.