The passenger compartment is heated by a heater whose matrix core, located under the instrument panel, is connected to the engine cooling system.
Note:
: replace the part with a new one after each removal.
: a special tool/device must be used.
: observe the tightening sequence.
D4F engine cooling system:1. Radiator of the cooling system. 2. Radiator outlet pipe. 3. Air outlet pipe to the expansion tank. 4. Expansion tank of the cooling system. 5. Inlet pipe of the water pump. 6. Radiator inlet pipe. 7. Water chamber bolt. 8. Water chamber bolt. 9. Water chamber. 10. Heater core pipes. 11. Water pump
Original of this article on the website www.RenaultBook.ru
Cooling system of the K7M engine:1. Radiator of the cooling system. 2. Radiator fan resistor assembly. 3. Air outlet pipe to the expansion tank. 4. Radiator outlet pipe. 5. Heater core pipes. 6. Water pump inlet pipe. 7. Radiator inlet pipe. 8. Water chamber. 9. Expansion tank of the cooling system.
Engine cooling system K4M:1. Radiator cooling system. 2. Radiator fan resistor assembly. 3. Radiator fan assembly. 4. Expansion tank air outlet pipe. 5. Radiator inlet pipe. 6. Radiator outlet pipe. 7. Expansion tank cap. 8. Cooling system expansion tank. 9. Water pump inlet pipe. 10. Water chamber gasket. 11. Water chamber. 12. Thermostat. 13. Thermostat seal. 14. Thermostat cover 15. Coolant temperature sensor. 16. Heater core inlet pipe. 17. Heater core outlet pipe.
Engine cooling system K8K:1. Radiator of the cooling system. 2. Radiator fan assembly. 3. Air outlet pipe to the expansion tank. 4. Expansion tank of the cooling system. 5. Water pump inlet pipe seal. 6. Water pump. 7. Water pump inlet pipe. 8. Radiator inlet pipe. 9. Water chamber gasket. 10. Water chamber. 11. Heater core outlet pipe. 12. Radiator outlet pipe. 13. Heater core inlet pipe.
