Removing the brake pedal
1. Remove the lower buffer element of the dashboard (if equipped).
2. Disconnect the connector from the brake pedal switch.
3. Remove the brake pedal switch by turning it a quarter of a turn counterclockwise.
4. Disconnect the accelerator pedal connector.
5. Remove the accelerator pedal.
1. Accelerator pedal. 2. Brake pedal switch. 3. Brake pedal pad. 4. Brake pedal. 5. Clutch pedal pad. 6. Clutch pedal. 7. Clutch cable.
Note: : replace the part with a new one after each removal.
6. Unlock connecting pin (10) between the brake pedal and the brake booster rod, turning in the direction (11), and extract in the direction (12).
7. To take an axis of a pedal of a brake.
8. Remove the brake pedal.
Installing the brake pedal
Check the condition of the parts.
Replace any defective parts with new ones.
Lubricate the brake pedal axle with multipurpose grease.
Installation is made in an order, the return to removal.
Adjust the brake pedal switch:
- Make sure the brake booster rod is connected to the brake pedal.
- Press the pedal with your hand.
- Install a switch.
Lock the switch by turning it a quarter of a turn clockwise.
At the same time, carefully release the brake pedal.
Note: The switch will automatically adjust when you fully depress the brake pedal. During automatic adjustment, characteristic clicking sounds will be heard.