Mixing chamber flap drive (Renault Logan 2)

Removal and installation

Removal

1. Disconnect the air flow distribution flap drive connector (1).

2. Disconnect the mixing chamber flap drive from the distribution block.

Installation

Installation is carried out in the reverse order of removal.

Note: Position the recirculation flap actuator relative to the flat edge of the actuator seat

[Text provided by an online resource: RENAULTBOOK.ru]

Note: Position the recirculation flap actuator relative to the flat edge of the actuator seat

Note: After installation is complete, it is necessary to perform the calibration procedure for the air conditioner computer and the mixing chamber flap actuator.

This article is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article has been reviewed by editor: Petrovsky Roman

Share with friends:

Logan 2: Heating and air conditioning

Air flow distribution flap drive
Recirculation flap drive
Cabin air temperature sensor
Heater and air conditioner control
Necessary precautions: operations with the air conditioning system

Ventilation system
Distribution block
Front side air vents
Middle air ducts of the leg area
Cabin filter