Attention! The fuel in the fuel system is under high pressure, so it is prohibited to loosen the fuel line connections while the engine is running or immediately after it has been stopped. To carry out repair work on the fuel system on an engine that has just been stopped, it is necessary to first reduce the pressure in the fuel system. 2–3 hours after the engine has been stopped, the pressure in the fuel system will drop to almost zero.
1. Turn off the ignition, open the hood and place it on the support.
2. Disconnect the wire from the negative terminal of the battery.
3. Press the left...
4. ...and the right mounting block cover clamps, remove the cover.
[This article is taken from the website RenaultBook]
5. Remove the fuel pump relay from the mounting block (shown by arrow).
6. Connect the wire to the negative terminal of the battery, start the engine and let it run until the fuel from the injector rail is completely used up. After that, the engine will stall.
7. Turn off the ignition. Now you can disconnect the fuel lines.