Removing
Remove the air filter housing.
Disconnect the crankcase ventilation hose (1).
Remove:
- cylinder head cover bolts,
- cylinder head cover,
- cylinder head cover gasket.
Installation
Clean the mating surfaces of the cylinder head with gray matting wheels.
Use a surface cleaner to degrease:
- mating plane of the cylinder head,
- socket for the cylinder head cover gasket in case of reuse.
- parts that must be replaced: cylinder head cover gasket.
Attention! Applying too much sealant can cause it to be squeezed out when parts are tightened. The ingress of sealant into the coolant can damage some components and assemblies (engine, radiator, etc.).
Carry four bead (1) silicone sealant with a diameter of 2 mm and a length of 10 mm.
Install:
- cylinder head cover,
- cylinder head cover bolts.
Torque tighten the cylinder head cover bolts in the order shown (12 Nm).
Attach the crankcase ventilation hose.
Install the air filter housing.