Contents: Removal 🠛 Installation 🠛
| Tightening torques | |
| Bolts for fastening the multifunctional bracket to the cylinder block | 44 Nm |
| Bolt for fastening the multifunctional bracket to the engine oil pan | 25 Nm |
Removal
Place the vehicle on a two-post lift.
Disconnect the battery.
Remove:
- right front wheel,
- right front fender liner,
- engine oil pan protection mounting bolts,
- engine oil pan protection,
- front bumper,
- accessory drive belt,
- generator.
Models with heater
Remove the power steering pump mounting bolts on the multi-function bracket (without disconnecting the hoses).
(This note was copied from the resource: «www.renaultbook.ru»)
Secure the power steering pump to the front body panel.
Models with air conditioning
Disconnect the air conditioning compressor connector.
Loosen the air conditioning compressor mounting bolts (without disconnecting the pipelines).
Secure the air conditioning compressor to the lower front cross member.
All models
Disconnect the wiring harness from the multi-function bracket.
Remove:
- bolts (1) for fastening the multifunctional bracket,
- multifunctional bracket.
Installation
Install the multifunctional bracket.
Loosely tighten bolts (1)-(7).
Pre-tighten the multi-function bracket mounting bolts (1) and (2) on the cylinder block to 5 Nm.
Loosen bolts (1) and (2) by half a turn.
Pre-tighten the multi-function bracket mounting bolt (7) on the engine oil pan to 5 Nm.
Pre-tighten the multi-function bracket mounting bolts (1) and (2) on the cylinder block to 5 Nm.
Pre-tighten the multi-function bracket mounting bolts (3), (4), (5), (6) on the cylinder block to 5 Nm.
Tighten the multi-function bracket mounting bolts to the cylinder block to the specified torque in the specified order (1), (2), (3), (4), (5), (6) (44 Nm).
Tighten the multi-function bracket to engine oil pan mounting bolt to the specified torque (25 Nm) (7).
Installation is carried out in the reverse order of removal.