- multifunctional bracket mounting bolts: 44 Nm;
- air conditioning compressor mounting bolts: 25 Nm;
- bolts of fastening of a rack of the compressor of the conditioner; 44 Nm;
- battery cover bolts: 4 Nm.
Removing
Place the car on a two post lift.
Drain the refrigerant from the refrigeration circuit.
Disconnect the battery.
Disconnect the wiring harness from the A/C compressor.
Disconnect the wiring harness from the refrigerant pressure sensor.
Disconnect the piping from the A/C compressor and the air conditioning piping between the compressor and the dryer receiver.
1 - block of wires of the refrigerant pressure sensor;
2 - pipeline compressor con-
3 - pipeline of the air conditioning system
Note. Be sure to plug the piping and reducer openings to prevent moisture from entering the system.
Loosen the A/C compressor mounting bolts.
Remove the air conditioning compressor. Turn off bolts 1 fastenings of a multipurpose arm.
Remove the multifunction bracket.
Installation
Install the multifunction bracket.
Tighten bolts and nuts to the required torque given in the table.
Install the generator.
Install in the reverse order of removal.
Connect the battery.
Charge the refrigeration circuit with refrigerant.
Check the operation of the air conditioner.