Install:
- left pendulum suspension support;
- the right support of the pendulum suspension;
- jet thrust.
Operations on the clutch slave cylinder in case of disconnection of the gearbox from the engine
Attention! To damage the slave cylinder. but apply lubricant to the gearbox input shaft.
Note. To prevent leakage of hydraulic fluid, replace the clutch slave cylinder when replacing the clutch cover.
Add fluid to the clutch fluid reservoir.
Bleed the air from the hydraulic drive.
To do this, connect a hose to hole C, and lower its free end into a reservoir filled with brake fluid.
Raise holder 2.
Move the hose to the first fixed position corresponding to the first O-ring,
Install an Arc 50 bleeder.
Turn on the bleeder.
Wait for the complete removal of air from the hydraulic actuator.
Attach the hose to the clutch slave cylinder.
Add brake fluid to the required level.
Check clutch operation.
Install the removed parts in order» reverse withdrawal.
Replace fixed bolts with new ones,
Run:
- filling the gearbox with oil;
- engine oil filling (if necessary);
- filling the cooling system with liquid and removing air from it;
- filling the power steering system and removing air from it;
- refueling the air conditioning system using the charging station.
Coat the threads of the brake caliper guide pin bolts with Loctite FRENBLOC and tighten them to the specified torque.
ATTENTION Securely fasten the brake hose and wires of the ABS wheel speed sensor.
Depress the brake pedal several times to set the brake pads into position.
Note. After installing the headlights, you need to adjust them.
Place the vehicle on a level surface.
Set the corrector knob to 0. Adjust.
If the vehicle is equipped with xenon headlights, the system must be initialized and the headlights adjusted.
Attention! For headlights equipped with xenon lamps, it is forbidden to turn on the lamp if it is not installed in the headlight unit (dangerous for the eyes).