Contents: Removal 🠛 Installation 🠛
| Tightening torques | |
| Bolts for fastening the multifunctional bracket to the cylinder block | 44 Nm |
| Bolt for fastening the multifunctional bracket to the engine oil pan | 25 Nm |
Removal
Place the vehicle on a two-post lift.
Disconnect the battery.
Remove:
- right front wheel,
- right front fender liner,
- engine oil pan protection mounting bolts,
- protective screen.
Remove the front bumper.
Remove:
- accessory drive belt,
- generator.
- power steering pump mounting bolts,
- bolt securing the high pressure pipeline to the cylinder block.
Secure the power steering pump to the front body panel.
Remove:
- bolts (2) for fastening the multifunctional bracket,
- multifunctional bracket.
Installation
Install the multifunctional bracket.
Loosely tighten bolts (1)-(7).
Source link is located on (www.renaultbook.ru)
Pre-tighten the multi-function bracket mounting bolts (1) and (2) on the cylinder block to 5 Nm.
Loosen bolts (1) and (2) by half a turn.
Pre-tighten the multi-function bracket mounting bolt (7) on the engine oil pan to 5 Nm.
Pre-tighten the multi-function bracket mounting bolts (1) and (2) on the cylinder block to 5 Nm.
Pre-tighten the multi-function bracket mounting bolts (3), (4), (5), (6) on the cylinder block to 5 Nm.
Tighten the multi-function bracket mounting bolts to the cylinder block to the specified torque in the specified order (1), (2), (3), (4), (5), (6) (44 Nm).
Tighten the multi-function bracket to engine oil pan mounting bolt to the specified torque (25 Nm) (7).
Install:
- power steering pump,
- power steering pump mounting bolts,
- bolt securing the high pressure pipeline to the cylinder block.
- generator,
- accessory drive belt.
Install the front bumper.
Reinstall the right front wheel.
Connect the battery.