Removal and installation of a combination of devices
Removing the instrument cluster
1. Using a scan tool, perform the pre-repair procedures for the instrument cluster.
2. Block the airbag processor.
3. Turn off the ignition.
4. Disconnect the negative battery terminal.
5. Remove the driver's airbag module.
6. Remove the steering wheel (see chapter "Steering").
Attention: To avoid damage to the contact disk, do not rotate its moving part.
7. Remove the upper and lower steering column covers (see section "Removal and installation of the dashboard").
8. Loosen the bolts (1) instrument cluster mountings.
9. Unhook the instrument cluster.
10. Disconnect the instrument cluster connector.
Installing the instrument cluster
1. Installation is made in the reverse order of removal.
2. Unlock the airbag processor.
3. Using the scan tool, perform a post-repair procedure for the instrument cluster.
4. Turn on the ignition and check the operation of the instrument cluster.