1. Before each trip, check and, if necessary, adjust the air pressure in the tires to the norm.
2. Do not allow the engine to operate at a crankshaft speed exceeding 3000–3500 min⁻¹.
3. Shift to a lower gear in a timely manner according to road conditions to avoid unwanted engine overload.
4. For better running-in of the brake pads, try to avoid sudden braking.
5. Avoid driving in deep snow, sand, and mud whenever possible.
6. Do not tow a trailer and, if possible, try to avoid towing other vehicles.
7. Use a "soft" driving style, avoiding sudden acceleration, braking, and maneuvering.
8. Do not exceed the speed of 130 km/h even on downhill slopes.
9. Periodically check and, if necessary, adjust the tension of the accessory drive belts (generator, power steering pump, etc.). During the initial period of operation, belts may stretch most intensively.
10. Monitor the condition of all fasteners of the car and tighten them if necessary. Pay special attention to the fastening of the wheels, steering components, front and rear suspensions, the exhaust pipe to the exhaust manifold of the engine.
During the break-in period (at 1000 km mileage) visit a service station for your first scheduled maintenance. To keep the warranty valid, ask the service station staff to make a note of the maintenance in the service book coupons.
After a run of 1000 km, the restrictions are lifted, but for the final running-in of engine parts, the car must travel approximately 3000 km.