Removing
Place the car on a two post lift.
Disconnect the battery.
Remove:
- engine top covers.
- engine undertray protection.
Disconnect:
- block of wires from the electric fan of the engine cooling system;
- block of wires from the resistor Release the harnesses from the holders;
- electric fan wires.
Remove the radiator mounting pins 1. Raise the radiator with a pad.
Remove:
- connecting rod mounting bolts 2.
- connecting traction.
- immersion heater mounting bolts.
Lower the vehicle to the desired height.
Lift the electric fan and separate it from the radiator of the engine cooling system.
Move hoses and immersion heater aside.
Remove the electric fan through the bottom of the car.
Installation
Install the electric fan through the bottom of the car.
Attach the electric fan to the radiator of the engine cooling system.
Install:
- connecting rod;
- connecting rod mounting bolts;
- immersion heater holder bolts.
Wrench:
- connecting rod mounting bolts;
- immersion heater holder bolts.
Remove the pad. Snap in the radiator mounting pins.
Attach:
- block of wires from the electric fan of the engine cooling system;
- resistor connector Attach wiring harnesses to electric fan
Install the engine guard/sump and engine top covers.
Connect the battery.