Removing
Remove the battery.
Disconnect the protection and switching unit 2 at points 1.
Move the Protection and Switching Unit aside.
Turn out a bolt 3 fastenings of an inlet air line.
Drill three non-removable bolts - using a drill with a diameter of 5 mm along the axis of the bolts.
Remove:
- three bolts of fastening of the shelf under the storage battery by means of the adaptation (Mot 1372);
- battery shelf.
Disconnect the connectors of the electric fan of the engine cooling system.
Disconnect the wiring harness from the electric fan.
Remove the engine cooling fan.
Installation
Install the engine cooling fan. .
Disconnect the wiring harness to the engine cooling fan.
Connect the engine cooling fan connectors.
Install:
- battery shelf.
- battery mounting bolts.
Tighten the butt bolts under the battery 21 Nm stop:
- intake air duct bolt.
- block of protection and switching.
- rechargeable battery.