Removing
Disconnect the battery.
Remove:
- fuel rail protection
- intake silencer.
Disconnect:
- power steering hoses on the electric fan,
- power steering pump reservoir from bracket at point (1),
- engine cooling hose at point (2).
Click on the latches of the dowel pins (3) the engine cooling fan with a screwdriver and slide it down in the direction of the arrow (4).
Tie up the power steering pump reservoir to the engine.
Remove the power steering pump reservoir bracket.
Models with heater
Disconnect the engine cooling fan connector (5).
Disconnect the electric fan wiring harness from the engine cooling system.
Take away from the electric fan of the engine cooling system the following items.
Loosen the engine cooling radiator bolts (6).
Models with air conditioning
Disconnect:
- engine cooling fan connector (7),
- engine cooling fan resistor connector (8).
Disconnect the electric fan wiring harness from the engine cooling system.
Take away from the electric fan of the engine cooling system the following items.
Loosen the engine cooling radiator bolts (6).
Disconnect the fasteners of the connecting pipeline between the condenser and the reducer at the point (9).
Attention! To avoid refrigerant leakage, do not damage (do not deform, bend, etc.) pipeline.
Pull the fan in the direction of the arrow (10), passing it under the connecting pipeline between the condenser and the gearbox.
All models
Note: Do not damage the cooling fins when performing this operation (radiator, condenser, etc.).
Remove the engine cooling fan from the top of the vehicle.
In case of replacement
Remove from the engine cooling fan:
- power steering hose holders,
- wiring holder.
Installation
In case of replacement, install on the electric fan of the engine cooling system:
- power steering hose holders,
- wiring holder.
Installation is made in an order, the return to removal.
Connect the battery.
Checking the operation of the electric fan of the engine cooling system
Start the engine.
Disconnect the wiring harness from the coolant temperature.
Check the operation of the engine cooling fan.
Connect:
- coolant temperature sensor connector,
- system sensor.
Stop the engine.