Removing
Place the car on a two post lift.
Disconnect the battery.
Remove the fuel rail guard.
Drain the liquid from the engine cooling system.
Disconnect:
- outlet hose (1) engine cooling radiator,
- hose (2) heater.
Disconnect the wiring harness from the water pump inlet at the point (3).
Disconnect the wiring harness from cylinder #3 injector.
Remove:
- bolt (4) fixing the inlet pipe of the water pump,
- water pump inlet pipe,
- water pump inlet gasket.
Installation
Parts that must be replaced:
- Gasket between water pump inlet and water pump.
- Hose clamps for the engine cooling system.
Install the water pump inlet pipe with a new gasket.
Torque tighten the water pump inlet pipe mounting bolt (22 Nm).
Attach:
- block of wires to the injector of cylinder No. 3,
- heater hose to water pump inlet pipe,
- outlet hose of the radiator of the engine cooling system.
Attach the wiring harness to the water pump inlet.
Install the fuel rail guard.
Fill the engine cooling system with liquid.
Connect the battery.
Remove air from the engine cooling system.