Warning indicator lamps
1. Engine oil pressure warning lamp
Depending on the equipment, a corresponding display appears on the multifunction display no. 30. The warning light comes on after the ignition is turned on and goes out after the engine starts. If the warning light comes on while driving, you need to stop, turn off the engine and check the engine oil level - if the oil level is normal, check the lubrication system.
- if the warning light is on despite the fact that the oil level in the engine is normal, you cannot continue driving, as the engine will be seriously damaged. Do not operate the engine even at idle speed - qualified assistance is required
2. Battery charging indicator lamp
Depending on the equipment, a corresponding display appears on the multifunction display no. 30. The warning lamp lights up when the ignition is turned on and goes out after the engine starts. The generator is driven by a durable poly V-belt.
If the warning light comes on while driving, you must stop. turn off the engine and check the condition of the serpentine belt, as well as the reliability of the connection of the wires to the generator terminals. If the belt is damaged or torn, the power steering pump and water pump will also not work, causing the engine to overheat (gasoline engines) In this case, you need to call technical assistance and deliver the car to a service center.
If the warning light is on and the drive belt is in good condition, you can continue driving to the nearest service center to have the charging system checked. To reduce battery discharge, turn off all non-essential electrical consumers.
3. Warning lamp for minimum engine oil level
Depending on the equipment, a corresponding display appears on the multifunction display no. 30.
If the warning light comes on, you must immediately turn off the engine. In this case, you need to check the engine oil level with a dipstick. if necessary, top it up. If necessary, call technical assistance to deliver the car to a service center.
4. Engine overheat warning lamp
Depending on the equipment, a corresponding display appears on the multifunction display no. 30
If the warning light comes on while the vehicle is moving, immediately stop the vehicle and leave the engine idling for 1-2 minutes. Turn off the engine, wait until it cools down and check the coolant level in the expansion tank, the tension of the water pump drive belt and the condition of the fuse protecting the radiator fan electrical circuit.
If the warning light does not go out, and the coolant level is normal and the fan fuse is working, stop driving and call technical assistance.
5. Low brake fluid level warning light
Depending on the equipment, a corresponding display appears on the multifunction display no. 30.
When the ignition is turned on, the control lamp lights up together with the indicator lamp for the applied parking brake, which tests the functioning of the lamps.
If the warning light comes on while the vehicle is moving (with or without the symbol «Stop»), this indicates a decrease in the level of brake fluid in the brake system reservoir.
In this case, stop the car, check the brake fluid level and, if necessary, bring it to normal. If you have to frequently add brake fluid, it means that the hydraulic drive of the brake system is leaking and there is a constant leakage of brake fluid. In this case, you should immediately find the nearest service center to check the service brake system.
6. Anti-lock braking system warning lamp «ABS» Depending on the equipment, a corresponding display appears on the multifunction display no. 30. The warning lamp warns of a malfunction in the anti-lock braking system. The warning lamp lights up for 3 seconds after turning on the ignition or during engine starting and goes out after the process of automatically checking the functionality of the system is completed. If the warning light does not light up a few seconds after turning on the ignition, does not go out, or lights up while driving. then the ABS is faulty. If the anti-lock braking system warning light illuminates while driving, the vehicle's braking system is operating without anti-lock braking system. If there are malfunctions in the anti-lock braking and braking systems, which are indicated by warning lamps during braking, the rear wheels may lock prematurely. You must immediately proceed with extreme caution to the nearest service center to have the fault rectified.
Service warning lamps
7. Indicator lamp for applied parking brake
The warning lamp lights up if the parking brake is applied when the ignition is turned on. After releasing the parking brake lever, the warning light should go out.
8. Minimum fuel indicator lamp
Depending on the equipment, a corresponding display appears on the multifunction display no. 30. The warning light works when the ignition is on. When the warning light comes on, you must refuel the car as soon as possible.
9. Indicator lamp for excessive brake lining wear
Depending on the equipment, a corresponding display appears on the multifunction display no. 30. If the warning light comes on when braking, the condition of the brake pads must be checked as soon as possible.
10. Indicator lamp for electronic control malfunction
Depending on the equipment, a corresponding display appears on the multifunction display no. 30. The warning light comes on when the ignition is turned on and should go out after 3 seconds. If the warning light comes on while the engine is running, there is a malfunction in the engine management system, the electronic input systems, the engine immobilizer and/or the automatic transmission control system and a service center should be consulted immediately.
11. Preheat indicator lamp (diesel engine)
Depending on the equipment, a corresponding display appears on the multifunction display no. 30.
The engine can be started after the warning light turns off. If the warning light comes on while the engine is running, there is a malfunction in the engine preheating control unit and you should immediately consult a service station.
12. Airbag warning lamp
Depending on the equipment, a corresponding display appears on the multifunction display no. 30. The airbag warning light comes on when the ignition is turned on and should go out after 3 seconds. If, when you turn on the ignition, the warning lamp does not light up or is constantly on, it means that there is a malfunction in the security system, and you must contact a service station as soon as possible.
13. Control lamp for controlled air suspension
Depending on the equipment, the corresponding indication appears on the multifunction display No. 30. It lights up when the ignition is turned on and goes off 3 seconds after the engine starts. If the warning light comes on while the vehicle is moving, it means that there is a serious malfunction in the controlled suspension that must be repaired immediately. In this case, you can continue driving at a speed of no more than 40 km/h. since this malfunction affects the vehicle's driving characteristics and braking.
15. Right turn signal indicator lamp
16. Left turn signal indicator lamp
17. Indicator lamp for turning on high beam headlights
18. Indicator lamp for low beam headlights
19. Indicator lamp for turning on side lighting
20. Indicator lamp for turning on the rear fog lights
21. Indicator lamp for turning on the front fog lights
22. Warning lamp for turning on seat heating
Information screen
23. Speedometer
The speedometer shows the actual speed of the vehicle.
To switch the display from mph to km/h, turn the ignition key to position «accessories», press and hold down the button located at the end of the windshield washer and wiper switch for a while. When the speed unit indicator starts flashing, press the «M» (position No. 29) minutes adjustment.
24. Vehicle daily/total mileage counter
To switch the meter from the total vehicle mileage mode to the daily mode, briefly press the button located at the end of the windshield washer and wiper switch. A car's odometer measures the distance a car has traveled since it was manufactured. The vehicle odometer measures the distance traveled by the vehicle since the meter was reset after pressing and holding down the button located at the end of the windshield washer and wiper switch, the display will begin to flash and an audible signal will confirm the reset.
25. Fuel gauge
If there are several liters of fuel left in the fuel tank, only one or two dashes of the indicator light up, while 8.5 liters of fuel remain in reserve and the warning lamp comes on (position No. 8) minimum fuel reserve
26. Engine oil level or coolant temperature indicator
After turning on the ignition, the gauge shows the engine oil level for 20 seconds or until the engine starts, then switches to indicating the coolant temperature.
Engine oil level
To check the engine oil level, place the car on a level horizontal surface and wait a few minutes for the oil to drain into the oil pan. Turn on the ignition without starting the engine and check the oil level. If one line lights up on the indicator, the oil level is minimal, and the warning light may come on (№3). Add oil to the required level as quickly as possible.
Coolant temperature The number of illuminated dashes of the indicator depends on the coolant temperature; eight dashes may be illuminated. Engine overheating is warned by the coolant temperature warning light coming on (№4) The indication of this indicator can be canceled by turning the ignition key to position «accessories», press and hold down the button located at the end of the windshield washer and wiper switch for a while. When the pointer starts flashing, press the button «N» (position No. 28) clock adjustments.
27. Time display
Setting the hours and minutes is done by pressing buttons No. 28 and 29.
28. Setting the time
Turn the ignition key to position «accessories» and pressing a button «N» set the required clock display.
29. Setting the minutes
Turn the ignition key to position «accessories» and pressing a button «M» set the required minute display.
30. Multifunction display (depending on equipment) The following information can be shown on the multifunction display:
- time and ambient temperature;
- service messages;
- radio information;
- message «OK» about the operation of the diesel engine preheating system
There is a priority control about the indication of the information displayed.
Time and ambient temperature
They are shown without a request. except for the position of the key in the ignition switch in position «Stop» Adjustment is the same in all versions (see No. 28 and 29).
Engine starting
Automatic testing is carried out when the ignition is turned on:
- on cars with gasoline engines, starting the engine is allowed after the indication appears «OK»;
- on cars with diesel engines indication «OK» appears for approximately 1 second, then the engine preheating indication appears for a few seconds. After the re-indication appears «OK» the engine must be started. The appearance of an indication in the form of a black square indicates that. that the engine has stalled.
Indication «STOP»: recommendation to stop the vehicle immediately after turning on the ignition or when the vehicle is moving instead of displaying «OK» may be highlighted «Stop» - a strong recommendation to immediately stop the car.
After the beep, the following messages or indicators may appear alternately:
- symbol of lack of battery charging appearing simultaneously with the indication «Stop» indicates an overload or malfunction of the charging system;
- engine oil pressure symbol appearing simultaneously with the display «Stop» indicates that the engine should be stopped immediately and the oil level checked.
- coolant temperature symbol appearing simultaneously with the display «Stop» indicates that. that it is necessary to immediately stop the car and leave the engine idling for 1-2 minutes. Then turn off the engine and wait until it cools down. and check the coolant level in the expansion tank, the tension of the water pump drive belt, and the condition of the fuse protecting the electrical circuit of the radiator fan:
- anti-lock braking system symbol appearing simultaneously with the display «Stop» indicates a malfunction of the anti-lock braking system.
- low brake fluid level symbol appearing simultaneously with the display «Stop» indicates a decrease in the level of brake fluid in the brake system reservoir
Note. If the low brake fluid symbol disappears and no longer appears. This means that the brake fluid level is normal, but you need to contact a service station.
Indication «SERVICE»
After turning on the ignition or when the vehicle is moving, instead of «OK» an indication may appear «SERVICE», which informs the driver about the need to present the vehicle for maintenance.
After the sound signal simultaneously with the indication «Service» The following messages or indicators may appear alternately:
- brake pad wear symbol, which appears every time the vehicle is braked and indicates the need to immediately check the brake pads;
- a symbol of a malfunction of the electronic control indicating that. that there is a malfunction in the engine management system of the electronic input systems, engine immobilizer and/or automatic transmission control system, in which case it is necessary to immediately consult a service station;
- low engine oil level symbol indicating this. that it is necessary to immediately turn off the engine, check the engine oil level with a dipstick and bring it to normal;
- The airbag symbol appears when there is a malfunction in the vehicle's safety system;
- The controlled air suspension symbol indicates this. that there is a serious malfunction in the control suspension that must be corrected immediately. In this case, you can continue driving at a speed of no more than 40 km/h. since this malfunction affects the vehicle's driving characteristics and braking.
Minimum fuel signal The first warning, accompanied by an audible signal, informs about this. that 8.5 liters of fuel remain in reserve. After the second warning appears. accompanied by an audible signal and the warning light coming on, you must immediately refuel the car
Radio information
When the radio status changes, a corresponding message appears on the multifunction display for a few seconds
31. Display the frequency of the received radio station (depending on equipment)
32. Engine oil level or coolant temperature indicator (depending on equipment)
See description of position No. 26.
33. Fuel gauge (in favor depending on equipment) See description of position No. 25. The only difference is that there is a second warning when the fuel level is at minimum. This warning is displayed continuously, reminding you to refuel your vehicle immediately.
34. On-board computer (depending on equipment)
The on-board computer screen displays five functions on vehicles with petrol engines and one function on vehicles with diesel engines.