Installation
- thoroughly wash the inside of the sump from oil deposits. Clean the mating surfaces of the sump and cylinder block from gasket residues;
Figure 3.48. Applying sealant at points A when installing the engine oil pan
Figure 3.49. Applying sealant at points B when installing the engine oil pan
- apply a small amount of Rhodorseal 5661 sealant to the surface of the pan in zones A on both sides of the 1st main bearing (Figure 3.48) and in zones B (Figure 3.49) front cylinder block cover;
Figure 3.50. Installing the engine oil pan gasket
- install a new gasket on the pan (Figure 3.50);
- install semicircular gaskets on the pallet and, applying it to the block, secure with bolts, tightening them crosswise first with a torque of 8 N·m and finally with a torque of 14 N·m;
- lift the subframe and remove the temporary threaded posts, replacing them with bolts;
- connect the steering gear shaft to the intermediate steering shaft and tighten the mounting bolt;
- perform the remaining operations in the reverse order of removal;
- fill the engine with oil, start it and check for leaks.