Removing
- on cars with power windows, disconnect the wire from the negative terminal of the battery;
- remove the front door trim panel;
- remove the door glass as described below, or lift and secure with adhesive tape so that it does not fall;
- remove interfering seals.
Glass removal
Figure 9.66. Disconnecting the connector from the power window motor
- on models with power windows, disconnect the connector from the power window motor (Figure 9.66);
Figure 9.67. Nuts of fastening of the engine of a window lifter of a forward door
- unscrew the nuts securing the window lifter (Figure 9.67) and two bolts securing the glass guide channel to the door (Figure 9.68);
Attention! three bolts (WITH) manual power window motor are not the power window motor mounting bolts.
Figure 9.68. Sliding glass guide channel bolts
- Carefully remove the power window through the lower hole in the door.
Installation
Installation is carried out in the reverse order of removal. Before installing the door upholstery, check the operation of the power window.