Removing
1. Move away from the glass, remove the cover of the upper brake light by pressing on the side clips of the cover (A).
2. Remove the brake light bracket.
3. Disconnect the connector (IN) rear window heater.
4. Through the opening in the luggage compartment, disconnect and remove the lower adjustment stops (WITH).
5. Apply tape around the glass to protect the painted surface of the door.
6. Pierce the glass sealant and pull the sealant cut wire. Cut off the sealant and remove the glass.
Installation
Note. Instructions for use of glass sealant can be found in the information sheet of the sealant manufacturer.
1. At a distance of X = 110 mm from the edge of the roof, glue the limiters (D) and install the lower adjusting stops (WITH).
Note:
- Lower adjustment stops (WITH) do not re-install.
- Before applying primer under sealant (E) We recommend sticking a protective tape on the surface (F).
1 - Roof, 2 - Glass, 3 - Ceiling panel, 4 - Sealant.
2. After gluing the glass, it should be slightly lower than the surrounding panels. The gap between glass and panels should be approximately equal around the entire perimeter.