All models except Scenic
1. Carefully detach the top of the mirror trim panel from the door, then release the trim panel from the adjustment lever and remove it from the door.
2. Remove the seal from the adjustment lever.
3. Wring out a screw-driver a cover and a lining, then turn away fixing nuts and remove a mirror from a door. Remove the rubber seal that is installed between the door and the mirror; if the seal is damaged, replace it.
4. Install in reverse order.
Scenic Models
1. Remove the exterior mirror trim panel from the front of the door.
2. Detach the cover installed on the door trim panel below the mirror (refer to accompanying illustration). Remove the rubber boot on the adjustment knob, then, working through the door opening, unscrew the clamping screw on the control housing. Press the locking tab on the side of the control housing to release the cables, then remove them.
3. Turn away three fixing nuts and remove a mirror from a door. Where available, remove the rubber seal that is installed between the door and the mirror.
4. Install in reverse order.
Electric Mirror
All models except Scenic
1. Carefully detach the top of the mirror trim panel and remove it from the door.
2. Remove the insulating foam and disconnect the motor wiring connector (refer to accompanying illustration).
3a. Pry off the cover and gasket with a screwdriver.
3b. Then loosen the fixing nuts.
3s. Remove the mirror from the door. Remove the rubber seal that is installed between the door and the mirror; if the seal is damaged, replace it (refer to illustrations).
4. Install in reverse order.
Scenic Models
1. Disconnect the exterior mirror trim panel from the front of the door.
2. Detach the cover mounted on the door trim panel below the mirror.
3. Working through the door opening, remove the two brackets securing the mirror control housing to the trim panel. Remove the control housing and disconnect the wiring connectors.
4. Turn away three fixing nuts and remove a mirror from a door. Where available, remove the rubber seal that is installed between the door and the mirror.
5. Install in reverse order.
Mirror glass
1. Fully tilt the top of the mirror glass and insert a wide wooden wedge between the mirror glass and the housing base. Gently pry the glass away from the motor/regulator with a screwdriver (refer to accompanying illustration). Be very careful when removing the glass; do not apply excessive force as the glass breaks easily.
2. Remove the glass from the mirror, where necessary, disconnect the electrical wiring from the mirror (refer to accompanying illustration).
3. When installing, connect the electrical wiring (where necessary) and secure the glass to the motor/regulator with brackets.
Mirror switch
1. Contact the Head Onboard electrical equipment.