Removing
1. Apply the handbrake, then jack up the front of the vehicle and place it on axle stands. Remove the front wheels.
2. Remove the screws securing the front wheel arch liners to each end of the bumper.
3. On models with fog lamps, trace the wiring to the connector and disconnect it from the main wiring harness.
4. On models with headlight washers, release the mounting brackets and disconnect the washer hoses.
5a. Remove the bolts securing the left and right ends of the bumper.
5b. Then remove the two bolts securing the rear of the bumper to the subframe (refer to illustrations).
6a. Remove the central fixing bolt at the top of the bumper.
6b. Then, with the help of an assistant, release the ends of the bumper and pull it forward (refer to illustrations).
7. Inspect bumper mounts for damage and replace if necessary.
Installation
1. Install in reverse order.