Front bumper components
Removing
Remove:
- three bolts and lower holder A of the lower elements of the protection of the front wing;
- bolts of fastening of protection of the pallet of a crankcase B (M6 head 10).
Loosen the fixing screws C (torx T20). holders D, then partially release the fender liner.
Disconnect connectors E power fog lights (if installed).
Remove the two side mounting bolts F.
Partially release the bumper, disconnect the fluid supply pipe to the headlight washer jets G (if installed).
Remove bumper (together with an assistant).
Installation
(together with an assistant)
Connect the fluid supply pipe to the headlight washer jets G (if installed).
Attach the bumper to the cross member and align the guides with the H slots.
Check that the bumper is securely fastened with the fender mounting clamp.
Fitting the part for installing headlight washer jets
Note. It is necessary to make a hole in the bumper if the headlight washer jets are located in it.
Then cut according to the existing marks (on the inside of the bumper).
Removing the headlight washer jet cover
Disconnect at point I.
To remove the headlight washer jet, lift the jet manually, then detach the trim at point J.
Remove the two fixing screws K.
Disconnect the fluid supply tube. then remove the jet.