Rear bumper components (-wagon-)
Removing
Remove three bolts of fastening of back lanterns A. Separate sockets, then remove lanterns.
Loosen the fixing screws B.
Remove the two holders (plastic rivets).
Remove the three lower holders D (plastic rivets).
Loosen the bolts E (torx T 20).
Unscrew the bolt securing the wing protection strip F (torx T20).
Remove side brackets G (plastic rivets).
Detach the bumper from the rear fender guards.
Disconnect the license plate light and parking system power connector (if installed).
Pull the bumper towards you and remove it (together with an assistant).
Installation (together with an assistant)
Apply sealant around the top fixing points H.
Note. Start tightening the light fixture with the inner mounting bolt A.