Removal and installation of the reverse switch
Removing the reverse switch
1. Place the vehicle on a two post lift.
2. Remove the front left wheel from the vehicle.
3. Remove the front left fender liner.
4. Unscrew the fastening bolts and remove the engine protective tray.
5. Drain the gear oil from the gearbox.
6. Disconnect connector (1) from the reverse switch.
7. Unscrew the reverse switch (2) with a special nozzle (Bvi. 1934).
Note: Seal the hole for the reverse switch in the gearbox housing.
Installing the reverse switch
1. Apply some silicone sealant to the threads of the reverse switch.
2. With a special nozzle (Bvi. 1934) install the reverse switch and tighten to 23 Nm.
3. Connect the reverse switch connector.
4. Refuel the gearbox.
5. Further installation is carried out in the reverse order of removal
Note:
: replace the part with a new one after each removal.
: you need to use a special tool/device.
1. Gearbox. 2. Boot of gearshift drive rod. 3. Laying of the mechanism of a gear change. 4. Bearing panel of the central tunnel. 5. Gear lever knob. 6. Gearshift drive rod. 7. Gearshift mechanism. 8. Washer. 9. Spacer. 10. Soundproof insert.