2. Always comply with the tightening torque specified in the specifications or in the text. Similar tightening torque values are grouped together.
3. All sealing washers, gaskets, lock washers, lock washers, cotter pins and sealing rings must be replaced during assembly. It is also necessary to replace the oil-tight rings each time they are removed from the shaft. Before installation, the lip of the seal must be lubricated. It is necessary to pay attention to the correct orientation of the seal when installing it.
4. The left or right side of the car is indicated based on the driver's position in the cabin, and the "in front" and "behind" directions are given in a similar way. Additional comments are provided in the text for clarification.
5. Please pay special attention to the fact that when repairing brakes, suspension and generally when performing work under the bottom, it is necessary to provide reliable support for the raised vehicle. The jack is used only when changing wheels. If you use a jack during repairs, the vehicle must first be jacked up and then placed on axle supports. You can also use a support tripod or garage jack. It is not recommended to use bricks as supports; if you use stones, it is necessary to place sufficiently strong wooden boards between the bottom of the vehicle and the stone.
6. Lubricants, oil, underbody protection and all mineral substances have a destructive effect on the rubber parts of the chassis and brake system. It is especially necessary to protect parts of the hydraulic system from these substances, which also include fuel. To clean the brake system, only brake fluid or alcohol should be used. However, it should be remembered that brake fluid is poisonous and can spoil the car's varnish.
7. When carrying out repairs, it is recommended to use only original spare parts. The only exceptions are parts of the electrical system or parts approved for use by the manufacturer.
8. When ordering spare parts, it is necessary to indicate the exact model name with the chassis number, if necessary - the engine number and the year of manufacture of the vehicle.
9. All repair work, especially on the brake system and steering, as well as suspensions, must be carried out with special care and caution.