2. When there are road repairs, turn on the hazard warning lights and install an emergency stop sign.
3. Secure the wheels on the opposite side of the vehicle against rollback with wooden wedges or blocks.
4. Remove the decorative cap with your hands or with a screwdriver resting on the edge of the wheel disk.
5. Loosen all wheel mounting bolts by one turn.
6. Raise the vehicle.
7. Unscrew the wheel mounting bolts and place them in the decorative cap.
8. Remove the wheel.
9. Place the spare tire on the wheel hub.
10. Insert the bolts and tighten them by hand.
[Original publication on the website: www.RenaultBook.ru]
11. Tighten the bolts in a cross pattern as tight as you can while rotating the wheel back and forth to center it on the wheel hub.
12. Lower the machine, tighten the bolts (80 Nm).
13. Install the decorative cap on the wheel.
Tire repair
Restoring a radial steel cord tire is a very complex process. If you notice a defect after a long time, the tire carcass may suffer from long-term driving with too low pressure and get internal damage. If moisture penetrates through a puncture, corrosion can damage the stabilizing steel cord. The most dangerous thing about this is that the damage cannot be seen from the outside. If the repaired tire is used under heavy load (high speed, full load), then it may suddenly burst. Installing a tube in this case will only be a temporary solution, as protruding parts of the cord can burst the tube. If in doubt, do not risk it and buy the same new tire.