Tightening torques | |
Bolts of fastening of the pump of the hydraulic booster of a steering to multipurpose at an arm | 21 Nm |
High pressure pipe fitting on power steering pump | 21 Nm |
Bolt of fastening of a flange of the pipeline of a high pressure on the block of cylinders | 21 Nm |
Removing
Place the car on a two post lift.
Disconnect the battery.
Remove:
- left front wheel
- accessory drive belt,
- protective screen.
Install clamp (Ms. 583) to the low pressure pipe of the power steering pump.
Remove clamp (1) power steering pump low pressure pipe using the tool.
Disconnect the low pressure pipe from the power steering pump.
Remove:
- bolt (2) attaching the high pressure pipe flange to the cylinder block,
- union (3) power steering pump high pressure pipe.
Disconnect the high pressure pipe from the power steering pump.
Install plugs on the piping and power steering pump to prevent contamination of the system.
Remove:
- bolts (4) mounting the power steering pump on the multifunctional bracket,
- power steering pump.
Installation
Install:
- power steering pump,
- power steering pump bolts to multifunction bracket.
Remove the plugs from the openings of the pipelines.
Install:
- fitting of the high-pressure pipeline to the power steering pump,
- high-pressure pipe flange-to-cylinder block bolt.
Torque tighten:
- power steering pump mounting bolts to multifunction bracket (21 Nm),
- high pressure pipe fitting on the power steering pump (21 Nm),
- bolt of fastening of a flange of the pipeline of a high pressure on the block of cylinders (21 Nm).
Connect the low pressure line to the power steering pump.
Install the low pressure line to the power steering pump using.
Remove the clip (Ms. 583) from the low pressure pipe of the power steering pump.
Install:
- engine undertray protection,
- accessory drive belt,
- right front wheel.
Fill the power steering system with ELF RENAULT MATIC D2 oil.
Bleed the air from the system by turning the steering wheel from one end to the other first with the engine off.
Bleed air from the system by turning the steering wheel from one end to the other while the engine is running.
Top up the oil level in the reservoir.
Make sure there is no fuel leakage.
Connect the battery.