Removing
Disconnect the battery.
Remove:
- screws on the lower steering column cover,
- stalk covers on the steering wheel,
- ring of system of electronic blocking of start of the engine.
Disconnect the connectors.
Remove:
- bolt (1) adjustment knobs,
- adjustment knob.
Note: Mark the position of the locking mechanism before removal.
Remove:
- nut (2) axis of the adjustment handle,
- needle bearing,
- the axis of the adjustment handle assembly with the locking mechanism.
Installation
Note: When installing the handle shaft, make sure that the two toothed segments are correctly installed (3).
Install:
- the axis of the adjustment handle assembly with the locking mechanism,
- needle bearing,
- adjustment knob axle nut,
- adjustment knob,
- adjustment knob bolt.
Note: The tightening of the handle axis determines the amount of force that must be applied when using it. Move the handle several times to determine if it is properly tightened.
Connect the connectors.
Install:
- ring of system of electronic blocking of start of the engine,
- stalk covers on the steering wheel,
- screws on the lower steering column cover.
Connect the battery.