Removing
Loosen the special nut (1) attaching the foam sound deadener to the left accelerator pedal assembly mounting nut.
Remove:
- nuts (2) fastening the accelerator pedal assembly,
- accelerator pedal assembly with mount.
Remove:
- throttle cable from the pedal side by lifting it and bringing the tip of the cable towards the center console,
- retaining ring (3) with a screwdriver.
Note: Remember the direction of installation of the axle in relation to the foot of the pedal assembly.
Remove:
- pedal axle,
- fuel control pedal.
Installation
Lubricate the axle with MOLYCOTE 33M grease.
Note:
- Set the axle to the position in relation to the pedal assembly support, memorized during removal.
- Do not tap the pedal axle with a hammer when installing.
Install on the accelerator pedal assembly:
- pedal,
- pedal axle,
- retaining ring.
Install the end of the throttle cable into the hole in the top of the accelerator pedal by inserting it from right to left and guiding the cable into the groove on the pedal.
Position the accelerator pedal assembly with the mount on the center console.
Install the accelerator pedal nuts.
Torque tighten the pedal nuts (21 Nm).
Install:
- foam soundproofing pad
- special nut for the noise dampening foam pad on the left nut for the accelerator pedal assembly.
Check the performance of the accelerator.