To replace it, you need to replace the accelerator pedal. There are two types of pedals: with or without a switch.
Vehicles equipped with a speed controller/limiter are equipped with an accelerator pedal with a switch at the end of the stroke (kick-down).
The switch is used to cancel the speed limit mode if the driver needs to increase it.
Attention! It is possible to install a pedal with a switch in place of a pedal without a switch. On the contrary, it is prohibited to install a pedal without a switch at the end of the stroke instead of a pedal with a switch.
Assigning contacts
1 - "Mass" of conductive track 2.
2 - "Mass" of conductive track 1.
3 - Conductive track signal 1.
4 - Power supply of conductive track 1.
5 - Power supply of conductive track 2.
6 - Conductive track signal 2.
Note: If the accelerator pedal position sensor is faulty, the engine will idle or the engine operating mode will change.
[This article is taken from the website: www.renaultbook.ru]
Removal
Disconnect the battery and accelerator pedal connector 1.
Remove the three mounting bolts 2 and the pedal.
Installation
Installation is carried out in the reverse order of removal.