Removing
Remove the stoplight switch.
Remove the connecting axle (1) between the brake pedal and the brake booster rod:
- unlock the axle according to (2),
- remove the axle according to (3).
Disconnect the ball head (4) master cylinder rod from the clutch pedal.
Install the two holders of the sound deadening material of the pedal assembly.
Remove the noise insulation of the pedal assembly (if there).
Lightly bend the sound deadening material.
Disconnect the steering column and steering gear.
Remove the pedal yoke nuts (5).
Cut through the soundproofing material to remove the pedal assembly fork if necessary.
Remove the pedal assembly.
If replacing, remove the brake pedal.
Installation
Mandatory replacement parts are subject to mandatory replacement: Connecting axle between the brake pedal and the brake booster rod.
Lubricate the axle with MOLYCOTE 33M grease.
If replacing, install the brake pedal.
Install the pedal fork.
Torque tighten the pedal assembly fork nuts (21 Nm).
Attach the steering column and steering gear.
Install a new connecting shaft between the brake pedal and the brake booster rod (pre-lubricated):
- insert the axle according to (7),
- block the axle according to (8).
Install:
- noise isolation of the pedal assembly (if there),
- stop light switch.
Check clutch operation.