Removing
Drain the fuel from the tank.
Place the car on a two post lift.
Disconnect the wires from the battery terminals, starting with the negative terminal.
Remove the right rear wheel.
Remove the right rear fender.
Pic. 2.27. Disconnecting the anti-pressure tube: 1 - anti-pressure tube; 2 – a clamp of a bulk pipe
Disconnect the anti-pressure tube and remove the filler pipe clamp (pic. 2.27).
Pic. 2.28. Unscrewing the bolts securing the filler tube: 1 - bolts
Loosen the filler neck tube bolts (pic. 2.28).
Pic. 2.29. Removing the filler neck: 1 - bolts
Loosen the filler neck bolts and remove the filler neck (pic. 2.29).
Installation
Clamps must be replaced with new ones.
Install in the reverse order of removal.
Attach the wires to the battery terminals, starting with the positive terminal.