Attention! During operation, do not allow engine oil to get on the drive belts.
Removing
Place the car on a two post lift.
Remove the engine undertray.
Pic. 2.3. Bolts of fastening of a strut of the compressor of the conditioner: 1 - fastening bolts
Remove the A/C compressor strut mounting bolts (pic. 2.3).
Remove the A/C compressor strut.
Pic. 2.4. Installing the special tool on the oil filter
Install special tool (Mot. 1329) to the oil filter (pic. 2.4).
Remove the oil filter.
Installation
Lubricate the oil filter gasket with fresh engine oil.
Screw in the oil filter until the gasket touches the surface of the engine.
Tighten the oil filter 3/4 turn by hand.
Install the A/C compressor strut.
Torque tighten (44 Nm) A/C compressor strut mounting bolts.
Add oil to the correct level.
Wipe off any oil spills with a rag.
Install the engine undertray.