Removing
Remove the wiper mechanism.
Disconnect the motor drive crank.
Pic. 7.111. Removing the wiper motor: 1 - fastening nut; 2 - fastening bolts
Remove the motor shaft mounting nut and the two motor mounting bolts (pic. 7.111).
Installation
Attention! Before installing the wiper crank, make sure the motor is in the same position as the original position of the wipers on the windshield.
Set the electric motor to the position corresponding to the original position of the brushes on the windshield.
Install the mechanism on the motor.
Tighten the mechanism fastening bolts to the required torque of 8 Nm.
Pic. 7.112. Installation of the mechanism drive crank: 1 - bosses
Position the mechanism drive crank between the bosses (pic. 7.112).
Torque tighten the motor shaft nut to 22 Nm.
Install the wiper mechanism.