Removal and installation the ignition module (Renault Logan 1)

You will need a TORX T30 key.

1. Disconnect the high-voltage wire ends from the ignition module...

2. ...and, having pressed the lock, the wiring harness block.

3. Remove the three bolts securing the ignition module...

4. ...and remove the module.

5. Install the parts in the reverse order of removal. Tightening torque of the ignition module mounting bolts is 15 N·m.

(Material taken from an online portal RENAULTBOOK)

Note: Before installation, lubricate the high-voltage wire tips with grease. The manufacturer recommends FLUORINE GREASE (catalog number 82 00 168 855), but you can also use technical petroleum jelly.

This article is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article has been reviewed by editor: Podkrepilov Maxim

Share with friends:

Logan 1: Power devices

Checking the ignition module
Design features of the engine management system
Disassembly and repair of the starter
Removal and installation the starter
Possible starter malfunctions

Removal and installation of the electronic engine control unit
Checking and replacing engine management system sensors
Spark plugs used in the car