- between walls - 11.4
- between sidewalks - 10.6
The number of steering wheel revolutions from lock to lock is 3.16
Power steering pump
On gasoline-powered vehicles, the pump is driven by a single multi-ribbed belt along with the water pump, alternator, and air conditioning compressor.
On vehicles with diesel engines, the pump is driven by a single multi-ribbed belt together with the alternator and the air conditioning compressor.
Pressure, bar:
- wheels are installed straight - 5-7
- wheels are turned all the way (gasoline engines) max — 86-93
- wheels are turned all the way (diesel engines) max — 93-103
- pressure difference when turning right and left - 5
Power steering fluid
Filling capacity, l - 1.1
Recommended fluid: Elf Renault Matic D2 or Mobil ATF 220
Maintenance frequency - fluid replacement is not provided, level is checked every 10,000 km ipoGera vehicle
Drive belt
The drive belt is common to all attachments: power steering pump, alternator and air conditioning compressor Belt tension, SEEM units:
- petrol engines without air conditioning system (between the crankshaft and power steering pump pulleys) — 107±3 (min 62)
- gasoline engines with air conditioning system (between the crankshaft and generator pulleys) — 109±3 (min 62)
- diesel engines without air conditioning system (between the crankshaft and power steering pump pulleys) — 116±8 (min 63)
- diesel engines with air conditioning automatically
Tightening torques, Nm
- Steering gear to sub-frame - 70
- Steering wheel nut (new) — 45
- Airbag mounting screw - 5
- Steering column mounting nuts - 15
- Nut securing the ball joint pin of the tie rod end - 40
- Tie rod axial ball joint - 50
- Bolt on the tie rod end adjusting sleeve - 20
- Steering shaft universal joint fork connection bolt - 25
- Power steering pump mount - 30
- Power steering pump pulley mounting (gasoline engines) — 8
- Bolts for fastening the power steering pump on the cylinder head cover of cars with Z - 50 engines
- High pressure pipe fitting on the hydraulic distributor - 22
- Low pressure pipe fitting on the hydraulic distributor - 30
Engine frame mounting bolt:
- front diameter 10 mm - 35
- rear diameter 12 mm - 110
Nut securing the stabilizer bar ball joint pin - 40