1 - Windscreen wiper motor holder mounting bolts; 2 - screws for fastening the windshield wiper motor to the holder; 3 - pin connection of the windshield wiper motor; 4 - rear fog light.
1. Remove the wiper blade arm.
2. Open the rear door and remove its inner cover (4 screws).
3. Carefully press out the trim (5 keys), otherwise you will have to install new keys.
4. Unscrew the wiper arm axle nut.
5. Remove the windshield wiper motor mount from the trunk lid by unscrewing the 2 mounting screws.
6. Disconnect the connector and remove the motor from the tailgate.
7. When installing, first install the motor loosely and tighten only after securing the outer nut of the wiper arm shaft.
8. Before installing the wiper arm, check that the motor is in the end position.
9. Install the tailgate trim only after checking the functionality of the mechanism.
Troubleshooting
malfunction | Cause | Troubleshooting |
| A. The rear window wiper does not work. | 1. The fuse is defective. 2. The connectors on the switch or motor are not installed correctly or are oxidized. 3. The wiring to the windshield wiper motor is broken. 4. The pin connection has oxidized. 5. The windshield wiper motor is faulty. | Replace. Put it on or clean it. Check the wiring, repair if necessary. |
| B.The rear window wiper operates continuously. | 1. The wires connected to the windshield wiper motor are mixed up. 2. The switch is jammed. | Connect the yellow wire to terminal B3, the pink wire to terminal B1. Replace. |