Removing the power window motor
1. Disassemble the inner lining of the door and remove the glass, see chapter Body and interior elements.
2. Disconnect the lift motor connector.
3. Unscrew the fastening of the lift mechanism in the door frame. To do this, unscrew the 3 nuts in the engine.
4. Turn off from the mechanism of the elevator 2 fastenings.
5. Turn the glass lift motor in the door frame and pull the lift mechanism out of the door with the motor forward.
6. Remove the engine.
7. Installation is carried out in the reverse order of removal.
8. Before fastening the door upholstery, check the operation of the device.
Trouble-shooting
Malfunction | Cause | Debugg |
A.The windows only move in one direction. | Switch defective. | Replace switch. |
B. The glass doesn't move in the direction. | 1. Severe glass movement in the guides, the fuse is faulty due to motor overload. 2. The motor does not run even though the fuse is good. | Make sure that the glass moves easily in the guides; replace the fuse. |
C. The glass moves very slowly over the entire stroke. | 1. Glass is stuck in the guides. | Check the glass gap and adjust if necessary. |
D.The glass moves slowly at the top of its stroke. | The glass is stuck in the guides. | Check the glass gap and adjust if necessary. |
Troubleshooting on the road
1. If one switch is faulty, then remove the other switch
2. Connect its switch to the place of the broken one. Now you can close the glass with a working switch.
3. If the wiring to the electric motor is broken, connect the auxiliary wire from the battery (if there is no positive current) or from mass (if there is no mass) to the engine and the glass will start to move.
4. If the lift motor is jammed, then you can remove the door lining and lift the glass manually up. To do this, remove the glass from the tire lift.
5. Raise the glass up and fix it in this position with a wooden wedge.
6. You can also fix the glass with a wide adhesive tape.