Removing
Turn on the ignition.
Move the wiper switch from position (0) into position (1), then from the position (1) into position (0).
Switch off the ignition.
Remove:
- rear window wiper arm,
- tailgate upholstery.
Disconnect connector (1) rear door power window motor power circuit.
Note: Take care not to damage the outer surface and door frame with the drill. Remove the rivets from the door frame.
Drill Rivets (2).
Remove the rear window wiper motor.
Installation
Replace gasket if necessary (3).
Install and rivet the rear window wiper motor.
Connect the rear window wiper motor power connector.
Turn on the ignition.
Attention! To ensure the correct trajectory of the wiper arms, it is necessary to initialize the wiper motor.
Move the wiper switch from position (0) into position (1), then from the position (1) into position (0).
Switch off the ignition.
Install:
- tailgate upholstery,
- rear wiper blade holders.