Tightening torques | |
Bolts of fastening of the case of the lever of a gear change | 21 Nm |
Exhaust pipe fittings | 22 Nm |
bottle nuts | 8 Nm |
Removing
Place the car on a two post lift.
Disconnect the battery.
Loosen the expansion tank nuts.
Disconnect the expansion tank from the bracket.
Models with K9K engine
Disconnect the air line between the turbocharger and the air cooler at the point (1).
Loosen the fastening nut (2) air line to the gearbox.
Remove the air line.
All models
Disconnect the select and shift cables from the transmission at the point (3).
Disconnect the stoppers of the sheaths of the select and shift cables on the gearbox by pressing in places (4).
Models with K9K engine
Loosen the mounting bolts (6) exhaust pipe to the catalytic converter.
Models with K4M engine
Remove the muffler intake pipes (7).
All models
Take aside the final pipeline.
Models with K4M engine
Remove:
- fastening nuts (8) heat shield,
- heat shield.
All models
Remove the center console.
Loosen the mounting bolts (9) gear lever housing.
Disconnect the shift lever housing from the floor by depressing the spring latches (10).
Lower the shift lever housing so that it rests on the exhaust pipe.
Remove the shift lever housing by passing it between the tunnel and the exhaust pipe.
Installation
Note: To facilitate attaching the selector and shift cables to the transmission, the shift lever housing and control levers on the transmission must always be in the neutral position.
Install the shift lever housing.
Fasten the shift lever housing to the floor.
Torque tighten the bolts securing the shift lever housing (21 Nm).
Install the center console.
Models with K4M engine
Install:
- heat shield,
- heat shield nuts.
All models
Tighten the stud nuts on the exhaust pipe to the catalytic converter.
Torque the exhaust pipe (22 Nm).
Fasten:
- sheath stoppers for select and shift cables on the gearbox,
- selector and shift cables to the gearbox.
Models with K9K engine
Tighten the air duct mounting nut on the gearbox.
Connect the air line between the turbocharger and the air/air cooler at the point (1).
All models
Install the expansion tank on the bracket.
Torque tighten expansion tank nuts B (Nm).
Connect the battery.