Tightening torques | |
ABS valve body mounting bolts on the bracket | 8 Nm |
Rigid piping fittings on the hydroblock | 13 Nm |
Wire nut «masses» hydroblock | 8 Nm |
Removing
Disconnect the battery.
Install a pedal hold tool on the brake pedal to reduce the amount of brake fluid escaping.
Remove the sound insulation holders of the bulkhead.
Move the noise insulation away from the bulkhead to gain access to the valve body.
Remove:
- fastening nut «mass» hydraulic block wires of the brake system (1),
- «mass» brake hydraulic unit wire (2).
Disconnect «mass» wire from the hydraulic unit at the point (3).
Disconnect the wire connector (4) from the ABS hydraulic unit.
Disconnect hard piping fittings (5) from the hydraulic unit.
Install plugs on the openings of the valve body and brake lines.
Remove:
- valve body bolts (6) from the bracket
- hydraulic block ABS.
Installation
Installation is made in an order, the return to removal.
Torque tighten:
- ABS valve body bolts on the bracket (8 Nm),
- rigid piping fittings on the hydroblock (13 Nm),
- fastening nut «mass» valve body wires (8 Nm).
Remove air from the brake system.